Craftsman 358.796480 Manual Del Operador página 9

ACCESSORIES
Safety Glasses ........... 71-85707
Extension Cord ........... 71-5702
CUSTOMER SERVICEABLE PARTS
Blade ................... 71-85718
Spring washer (blade) .. 530-402971
Hex Nut (blade) ....... 530-402954
Lock Nut (tube) ........ 530-403094
Rear wheel ........... 530-095088
Front wheel ........... 530-095087
Blade Guard .......... 530-402859
Edge guide ........... 530-402865
Rear axle ............. 530-403071
Front axle ............ 530-402875
Washer (axle) ......... 530-403136
Cup Washer (axle) ..... 530-016276
Locknut (axle) ......... 530-016245
Lockwasher (axle) ..... 530-016255
Spacer (axle) ......... 530-403109
Screw (edge guide) .... 530-016227
Screw (tube) .......... 530-402888
Washer (T-handle) ..... 530-402887
Prepare unit for storage at the end of
the season or if it will not be used for
30 days or more.
WARNING:
• Secure tile unit before storing or
transporting.
• Store unit with all guards in place.
Position unit so that any sharp object
cannot accidentally cause injury.
• Store unit well out of reach of children.
EDGER STORAGE
• Clean the entire unit.
• Inspect the blade area and clean any
dirt, grass, leaves, or debris that has
collected. Inspect the blade and
blade guard; replace a blade that is
bent, warped, cracked, broken, or
damaged in any other way.
• Replace a damaged or worn blade
guard.
• Lightly oil external metal surfaces.
CAUTION: Wear protective gloves
when handling the blade. The blade is
sharp and can cut you even when it is
not moving.
• Apply a coating of oil to entire surface
of blade; wrap it in heavy paper or
cloth.
• Be sure all handles and guards are
in place and are securely fastened.
Replace any damaged parts.
• Check entire unit for loose screws,
nuts, and bolts. Replace any dam-
aged, worn, or broken parts.
• Do not cover with plastic. Plastic can-
not breathe and will induce condensa-
tion and eventual rust or corrosion.
TROUBLESHOOTING CHART
SYMPTOM
Blade stops
under a load
or does not
turn when
switch is
pressed.
CAUSE
• Forcing blade into material.
• Blade guard clogged with debris
• Edge guide bent toward blade.
• Unit unplugged.
• Fuse blown/circuit breaker off.
• Worn spring washer.
• None of the above.
REMEDY
• Cut at a slower pace.
• Clean blade guard area.
• Replace edge guide.
• Plug unit into a 120 volt outlet.
• Replace fuse/reset breaker.
• Replace spring washer.
• Contact your SEARS Service
Center/Dept.
Blade turns •Wheel depth incorrect. •Adjust wheel to proper depth.
but will not cut • Incorrect or worn blade. • Replace blade.
• Worn spring washer. • Replace spring washer.
Edger drags •Wheel depth incorrect. •Adjust wheel for proper depth.
ground or •Wheel mount(s) broken. •Contact your SEARS Service
cuts too Center/Dept.
deep.