Craftsman 358.796480 Manual Del Operador página 3

Idiomas disponibles

Idiomas disponibles

finger onthe switch. Besure the
switch i snot i nthe onposition when
connecting
the extension
cord.
DANGER: RISK O F CUT KEEP HANDS
AND FEET AWAY FROM BLADE
AND CUT-
TiNG A REA. Do not a ttempt toclear away
cutmaterial
when t he blade i sinmotion.
Make s ure s witch isinthe off p osition and
thepower source isdisconnected
when
removing
jammed material
from the cut-
ting blade. Do not g rab o rhold u nit b y the
cutting blade.
®
CAUTION:
Blade rotates
momentarily
after the switch is released.
ELECTRICAL
SAFETY
• Use only a 120 A.C. voltage
supply
as shown on the nameplate
of unit.
• Avoid dangerous
situations.
Do not
use in the presence
of flammable
liq-
uids or gases to avoid creating a fire
or explosion
and/or causing
damage
to unit.
WARNING:
Avoid a dangerous
environment.
To reduce the risk of
electrical
shock, do not use in rain, in
damp or wet locations,
or around
swimming
pools, hot tubs, etc. Do not
expose
to snow, rain, or water to avoid
the possibility
of electrical
shock.
WARNING:
To reduce the risk of
electrical
shock, use extension
cords
specifically
marked as suitable for out-
door appliances
having an electrical
rating not less than the rating of the
unit. The cord must be marked with the
suffix "W-A." Use a polarized
cord.
Make sure your extension
cord is in
good condition.
Replace damaged
cords. An undersized
extension
cord
will cause a drop in line voltage
result-
ing in loss of power and overheating.
If
in doubt, use the next heavier gauge.
The smaller the gauge number the
heavier the cord (NOTE: The chart in
the Extension Cord section shows cor-
rect size to be used depending
on cord
length).
• Do not attempt to repair unit. Inspect
insulation
and connectors
on unit
and appliance
cord before each use.
If there is any damage,
do not use
until damage is repaired by your
Sears Service Center/Department.
• Inspect extension
cords before each
use and replace if damaged.
• Don't abuse cord. Never carry unit
by the cord or yank extension
cord to
disconnect
unit.
• To reduce the possibility
of the ex-
tension
cord disconnecting
from the
unit during operation, tie the power
cord on the unit to the extension
cord
as shown in the Extension
Cord sec-
tion. Insert cord socket on the unit
into the extension
cord receptacle.
• Do not use unit if the switch does not
turn the unit on and off properly. Re-
pairs to the switch must be made by
your Sears Service Center.
• Keep extension
cord clear of opera-
tor, unit, and obstacles
at all times.
Do not expose
the cord to heat, oil,
water, or sharp edges.
• Avoid any body contact with any
grounded
conductor,
such as metal
pipes or wire fences,
to avoid the
possibility
of electric shock.
• Ground Fault Circuit Interrupter (GPOI)
protection should be provided on the
circuit or outlet to be used for this
unit. Receptacles
are available
hav-
ing built-in GFCI protection
and may
be used for this measure of safety.
• To reduce the risk of electric shock,
this unit has a polarized
plug (one
blade is wider than the other) and will
require the use of a polarized
exten-
sion cord. This plug will fit into a po-
larized extension
cord only one way.
If the plug does not fitfully
into the
extension
cord, reverse the plug. If it
still does not fit, obtain a correct po-
larized extension
cord.
A polarized
extension
cord will re-
quire the use of a polarized
wall out-
let. This plug will fit into the polarized
wall outlet only one way. If the plug
does not fit into the wall outlet, re-
verse the plug. If it still does not fit,
loading