Idiomas disponibles
Idiomas disponibles
OPERATION
Note: Reset the controller to its default settings after assembly.
1.
Resetting the controller (Calibration)
After switching on, move the work surface to its lowest position. Press and hold the "△"
and "▽" buttons at the same time (or "RST") until "
release the buttons. The system will automatically return to its default setting.
2.
Height adjustment
If you press and hold the "△" button until the display flashes: button the work surface
moves upwards until it reaches its highest point. Press the button again when the
desired height is reached.
If you press and hold the "▽" button until the display flashes: button the work surface
moves downwards until it reaches its lowest point. Press the button again when the
desired height is reached.
Caution: If the table is lowered without the memory function, the automatic height
adjustment stops at 76cm for safety reasons. From this height, the table must be
lowered manually to reach the lowest setting of 72cm.
3.
Memory and operation
Saving the standing height: Move the work surface to the desired standing height, press
and hold the "M" button until the display reads "
button "△", the display flashes and shows the stored height, the standing memory has
thus been stored successfully.
Saving the sitting height: Move the work surface to the desired seating height, press
and hold the "M" button until the display reads "
"▽" button, the display flashes and shows the saved height, the seat memory has thus
been saved successfully.
Press the "△/▽" button for more than 3 seconds so that the height display flashes.
Release the button and the work surface will automatically move to its stored position.
Note: The standing height must be higher than the sitting hight when you save to the
memory, otherwise the setting cannot be stored.
4.
Movement reminder function
Turn on the reminder function by pressing the "M" button. The display shows "
When the time is up, the display flashes "Chr" for 1 minute. If the desk isn't used after 5
consecutive reminders, the function turns off automatically.
Turn off the reminder function by pressing the "M" button. When the display shows the
height, the reminder is turned off.
MAINTENANCE AND CARE INSTRUCTIONS
Always switch off the appliance and disconnect the mains plug before carrying out maintenance
or checks.
": 30 minutes, 45 minutes and 60 minutes.
" appears on the screen. Then
", then release the button. Press the
", then release the button. Press the
9
www.DEUBAXXL.de
