Idiomas disponibles
Idiomas disponibles
Fastening the shoulder harness strap
Always use the shoulder harness strap when using the
brush cutter.
1. Attach the shoulder harness strap hook to the
shoulder harness strap clip;
2. Adjust the strap so that the left hand can
comfortably hold the handle at approximately waist
height;
3. Make sure shoulder strap is properly attached;
OPERATING INSTRUCTIONS
When using the brush cutter, you should take into
consideration some precautions and procedures of use
in order to avoid accidents, damage and increase the
performance of the equipment:
▪ Ensure that you start your brush cutter at a distance
of more than 3m from the fueling site;
▪ Always hold the machine with both hands and keep
it on the right side of your body;
▪ Keep the cutting accessories below waist level, thus
reducing the risk of being hit by projected objects
during operation.
▪ Do not use the appliance to cut branches or logs. If
you try to cut logs above the recommended size,
kickback can occur and cause accidents to the user;
▪ When the device is running at idle speed, the cutting
accessory is not rotating. Otherwise, contact
technical assistance to carry out an inspection and
solve the problem;
▪ If you hear an unusual noise or the brush cutter
vibrates abnormally, stop working and identify the
cause;
▪ Never use the brush cutter if the guard is not placed
or if it is damaged.
40
Starting the engine
1. Move the CHOKE lever to "CLOSE" position. Move the
CHOKE lever until it touches the top;
If the engine is warm or the air temperature is high, do
not set the CHOKE lever to "CLOSE" position.
2. Press the carburetor primer bulb several times until it
is filled with petrol. Check that the fuel line is full, then
the carburetor is filled with fuel.
3. Set the "ON/OFF" switch to position (I);
4. Press the safety lever and the throttle trigger
simultaneously. Press the throttle trigger lockout to lock
the throttle;
5. Hold the brush cutter with one hand and pull the
starter handle. Pull slowly until you feel some
resistance, then pull hard until the engine starts to run;
6. After the engine has started, the brush cutter runs at
an intermediate speed between idle speed and
maximum speed. If you want to run the engine at idle
speed, press and release the throttle trigger;
7. A few seconds after the start, move the CHOKE lever
to "OPEN" position. Move the CHOKE lever until it
touches the bottom.
When the starter handle returns to the original
position, the hand and arm can be moved quickly
towards the combustion engine.
Let the engine warm up at idle speed for a few
seconds before using the brush cutter.
Stopping the engine
1. Release the throttle trigger and set the "ON/OFF"
switch to position (0);
2. If the throttle is locked with the throttle trigger
lockout, press and release the throttle trigger;
3. Set the "ON/OFF" switch to position (0);
In case of imminent danger or emergency, stop the
engine immediately. Set the "ON/OFF" switch to "0";
