Idiomas disponibles
Idiomas disponibles
5. Confirmation for use of sub fence (B)
WARNING
When left bevel angle cutting, loosen the 6 mm
wing bolt, then slide the sub fence (B) outward,
as shown in Fig. 12.
Failure to do so may result in the main body or
saw blade coming into contact with the sub
fence (B) and causing injury.
This power tool is equipped with a sub fence (B). In
the case of direct angle cutting and right bevel angle
cutting, use the sub fence (B). Then, you can realize
stable cutting of the material with a wide back face.
CAUTION
In the case of direct angle cutting and right bevel
angle cutting, slide inward to the position where
the sub fence (B) hits, and secure it with 6 mm
wing bolt. (as shown in Fig. 12)
Sub fence (B)
Fence (B)
6. Oblique angle
WARNING
When changing the oblique angle, hold down the
motor head. If the motor head moves to an
oblique angle suddenly, it may result in injury or
damage to the main body.
Before the power tool is shipped from the factory, it is
adjusted for 0°, right angle, left 45° bevel cutting
angle and right 45° bevel cutting angle with the 8 mm
set screws.
When changing the adjustment, change the height of
the 8 mm set screws by turning them. (Fig. 13-a,
Fig. 13-b)
When changing the bevel angle to the left 45°, loosen
the 6 mm wing bolt shown in Fig. 12, then slide the
sub fence (B) outward and incline the motor head to
the left.
Mounting position of
the sub fence (B)
6 mm wing bolt
Fig. 12
To change the bevel angle to the right at 45°, move
the sub fence (A) outward and loosen the bevel lock
handle, then pull out the set pin (A) toward the front,
and tilt the motor head to the right. (Fig. 13-b)
When the motor head is straight upright, the set pin
(A) is held tightly in place, so tilt the motor head
slightly to the left when pulling out the set pin (A)
before tilting the motor head to the right.
When adjusting the motor head to 0°, always return
the set pin (A) to its initial position as shown in
Fig. 13-b.
Indicator
(For bevel scale)
Fig. 13-a
8 mm set screw
(For right angle)
8 mm set screw
(For right 45° bevel angle)
Fig. 13-b
English
8 mm set screw
(For left 45° bevel angle)
Indicator
(For bevel scale)
Set pin (A)
Pull
17
