Idiomas disponibles
Idiomas disponibles
Adjusting the Leg Extensions
NOTE: It is highly recommended that BOTH leg extensions are
extended the same amount.
1. Lift outer leg slightly to relieve the ball detent pin.
2. Pull the ball detent pin out of the wheel base leg.
3. Slide leg extension out to desired position.
NOTE: If NOT using the anchor system, the front wheels MUST be
past the load.
4. Push the ball detent pin through the entire outer leg.
WARNING
CAUTION
Dimensional values are provided in inches. Bracketed values [ ] within diagram represent equivalent measurements in millimeters for
informational purposes only.
Failure to install the tab into the slot on the pedestal base bracket may result in the
crane tipping under load.
Factory supplied wheel base mounting bolts to be used for fl oor-mounting with
anchors only.
Wheel Base Operator's Manual • OZ Lifting Products, LLC
TO AVOID THE RISK OF ACCIDENTS, INJURY, OR DEATH:
Never lift a load with the boom arm extended past the front wheels.
Always vertically align the front leg wheels to the boom wheel.
D0029
Figure 9
®
• 1/2024
OPERATION
Follow the CORRECT instruction diagram below.
INCORRECT
CORRECT
19
