Idiomas disponibles
Idiomas disponibles
PART NUMBERS COVERED BY THIS MANUAL
This manual covers the set up and use of the following part numbers:
SET UP INSTRUCTIONS
in.oz and in.lbs Models
1.
Identify a suitable surface and position to mount the instrument.
2.
Drill two mounting holes suitable for M6 fasteners (M6 Cap Screws of grade 8.8 minimum are
recommended).
3.
Recommended fastener torque of 5.4 to 6.2 ft.lbs.
4.
After connecting the provided power supply the instrument will be ready to use after approximately 12
seconds.
ft.lbs Models
1.
Identify a suitable surface and position to mount the instrument.
2.
Drill two mounting holes suitable for M10 fasteners (M10 Cap Screws of grade 12.9 minimum are
recommended).
3.
Recommended fastener torque of 25 to 30 ft.lbs
4.
After connecting the provided power supply the instrument will be ready to use after approximately 12
seconds.
WARNING:
The Digital Torque Checker is intended for testing torque tools only.
Part Number
JHWDTCMM240-O
JHWDTCMM100-I
JHWDTC10M300-I
JHWDTCSF300-F
JHWDTC27M800-F
JHWDTC27M1500-F
ENSURE THE MOUNTING SURFACE IS CAPABLE OF SUPPORTING THE
INSTRUMENT WHEN THE RATED CAPACITY TORQUE IS APPLIED.
ONLY USE THE POWER SUPPLY PROVIDED.
DO NOT APPLY TORQUE ABOVE THE RATED CAPACITY.
Range
5.0-240.0 in.oz
5.0-100.0 in.lb
15.0-300.0 in.lb
7.5-300.0 ft.lb
40.0-800.0 ft.lb
75.0-1500.0 ft.lb
4
4
