Makita HM1111C Manual De Instrucciones página 6

After installing, always make sure that the bit is securely
held in place by trying to pull it out.
► 1. Releasing cover
To remove the bit, pull the releasing cover down all the
way and pull the bit out.
Bit angle
1
► 1. Change ring
The bit can be secured at 12 different angles. To
change the bit angle, slide the change ring forward,
then turn the change ring to change the bit angle. At the
desired angle, slide the change ring back to the original
position. The bit will be secured in place.
1
OPERATION
Chipping/Scaling/Demolition
Always use the D-shaped side handle or side grip (aux-
iliary handle) and firmly hold the tool by both D-shaped
side handle or side grip and switch handle during oper-
ations. Turn the tool on and apply slight pressure on
the tool so that the tool will not bounce around, uncon-
trolled. Pressing very hard on the tool will not increase
the efficiency.
MAINTENANCE
CAUTION:
•
•
6 ENGLISH
Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.