Idiomas disponibles
Idiomas disponibles
C3. Use top cabinet template for
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
*
Read the instructions on the TOP CABINET
TEMPLATE.
*
'Tape it underneath the top cabinet.
*
Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in
the cabinet bottom.
C4. Adapting microwave blower for
outside back exhaust =
4. Remove and save screw that holds blower Plate to
microwave.
Blower motor screw
2. Lift up the Blower Plate.
Blower motor
Back of
Microwave
Blower motor screw
3. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the blower
unit.
BEFORE: Fan Blade Openings
Facing Forward
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the
blower is removed and re-installed.
4. Remove "Parts 'A' with tin snips or pliers
Knockouts
Parts 'A'
CAUTION: After removing Parts 'A' Surely remove the
cutting sharp edge for safety. And Please be careful not
to be injured by sharp edge when working.
5. Rotate blower unit counterclockwise 180°.
Before Rotation
After Rotation
Back of Microwave
Back of Microwave
6. Place the blower unit back into the opening.
AFTER: Fan Blade Openings
Facing Back
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of microwave
oven.
7. Secure the blower unit to the microwave with the
screw.
E
Blower-Plate
Back of
Microwave ————"
From the Mounting
Plate screw
19
