Idiomas disponibles
Idiomas disponibles
B3. Adapting microwave blower for
outside
topexhaust
4. Remove and save
screw that holds blower
plate to microwave.
Blower Plate
=
Screw
2. Lift up the
blower plate.
'o eo,
a
Pe, to,
a, Fe,
Fe, 2, fe
Back of
Microwave
3. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the blower
unit.
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the
blower is removed and re-installed.
4. Roll the blower unit 90° so that fan blade openings
are facing toward the top of the microwave.
BEFORE: Fan Blade
Openings Facing
Forward
AFTER: Fan Blade
Openings Facing
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6. Lower the blower plate into original position and
secure blower unit to microwave with the screw.
B4. Installation procedure for
exhaust adaptor and proper damper
operationcheck
1. Remove and save screw from the panel-outer
Exhaust Adaptor
and Damper is
shipped after being assembled to
the filler-upper.
2. Slide exhaust adaptor following the instructions show
in diagram.
3. Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
4. Lift damper and Re-screw at same location as (1).
«
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave is installed.
15
