Idiomas disponibles
Idiomas disponibles
Clean Filter
The "Clean Filter" light will come on to tell you it is
time to change
your filter
GEApp/iances.com
Oo Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner
was not designed
for
fleezing
outdoor
conditions.
It must not be used in
fleezing
outdoor
conditions°
Remote Control
To ensure
proper
operation,
aim file reItlote
control
at the signal receiver
on the air
conditioner
The remote
conuol
signN has a range of
up to 20 feet.
Make sure noflfing is bet_,veen file air conditioner
and the
remora
control that could block the
signN.
Make sure baueries are flesh and installed
correctl}. _ks indicated on the remote control.
Cool Mode
Use the Coo/mode at tow, Met/, High or Auto Fan
Speed for cooling.
Use the TemperatureIncrease A /
Decrease Y pads to set the desired
temperature
between
62°F and 86°F in 1 °F increments.
An electronic
thermostat
is used to maintain
the
room mmperamre.
The compressor
will cycle on
and off to keep the room at the set level of comfort.
Set the them_ostat
at a lower number
and the indoor
air will become
cooler
Set the themlostat
at a higher
number
and the indoor
air will become
wam_e_:
NOTE: If the air conditioner is offend is then turned on
while set to a Cool setting or if turned from a fan setting
to a Cool setting, it may take approximatdg 3 minutes
for the compressorto start and cooling to begin.
Cooling Descriptions
For Normal Cooling--Select
the Cool mode
and
High or Med tim with a middle set temperature.
For Maximum Cooling--Select
the Cool mode
and High fan with a lower set mmperamre.
For Quieter and Nighttime Cooling--Select the
Cool mode and lOW fan with a middle
set
temperature.
Energy Saver Mode
Controls
the tim.
0N--The
fan will cycle on and offwith
the
compressor
This results in wider variations
of room
mmpemmre
and humidity.
Nomm/ly
used when
the
room is tmoccupied.
NOTE: Thefan 1778}/continue t o run
for a short time after the compressorcycles off
OFF--The tim runs all file time, while the
compressor cycles on and (fie
Fan Mode
Use file Fan Mode at Low, Med or High fan speed
to
provide
air circulation
and filtering
wiflK_ut cooling.
Since fan-only settings
do not provide
cooling,
a
Set mmperamre
cannot
be enmred.
The room
mmperamre
will appear
in the display.
NOTE." AutoFanSpeed is available in theFan Mode.
AutoFanSpeed
Set to Auto tim speed
for the fan speed
to
automatically
set to the speed needed
to provide
opfilntltll
COHlf()I't
settings with the set mmpemmre.
If the room needs
more
cooling,
the fan speed
will automatically
increase.
If the room needs
less
cooling,
the fan speed will automatical1)
decrease.
NOTE:Auto FanSpeed is available in theFanMode.
Power Outage Recovery Feature
In the case of a power outage
or interruption,
the
unit will automatically
restart in the settings
hst
used after the power is restored.
If the
Delay
1-24hr
feature
was set, it will resmne
cotmtdown.
You me}.
need
to set a new time if desired.
5
