Idiomas disponibles
Idiomas disponibles
6
EXPANSION CARD X-DANTE
(CN)
安全须知
1.
请阅读这些说明。
2.
请妥善保存这些说明。
3.
请注意所有的警示。
4.
请遵守所有的说明。
5.
请勿在靠近水的地方使用
本产品。
6.
请用干布清洁本产品。
7.
请勿堵塞通风孔, 安装本产
品时请遵照厂家的说明, 通风
孔不要覆盖诸如报纸、桌布和
窗帘等物品而妨碍通风。
8.
请勿将本产品安装在热源
附近, 如暖气片, 炉子或其它产
生热量的设备 （包括功放器）
。 产品上不要放置裸露的火焰
源, 如点燃的蜡烛。
9.
请只使用厂家指定的附属
设备和配 件。
10.
请只使用
厂家指定的
或随货销售的
手推车, 架子,
三 角架, 支架和
桌子。 若使用
手推车来搬运设备, 请注意安
全放置设备, 以 避免手推车和
设备倾倒而受伤。
11.
如果液体流入或异物落入
设备内, 设备遭雨淋或受潮, 设
备不能正常运作或被摔坏等,
设备受损需进行维修时, 所有
维修均须由合格的维修人员进
行维修。
Warning
Failure to observe the following warnings may lead to
fatality or serious injury from fire or electric shock.
Before installing the card, you must refer to the owner's manual of
the host device or to behringer.com to verify that your host device
supports this card, and to verify the number of cards that can be
installed in combination with other Behringer or third-party cards.
• •
Do not attempt to disassemble or modify the card. Do not
apply excessive force to board connectors or other board
components. Mishandling of board may lead to shock,
fire hazard, or equipment failure.
• •
Disconnect the power cable from the main unit before
installing this card to eliminate shock hazard.
Caution
Failure to observe the following precautions may
lead to personal injury, or may result in damage to
equipment or other property.
• •
Do not touch the board's metallic leads (pins) when handling
the card. Pins are sharp and may cause injury.
• •
The card is electrostatic-sensitive. Before handling
the card, you should briefly touch the main unit's
metal casing with your bare hand so as to drain off
any static charge from your body. Behringer assumes
no responsibility for data loss, equipment damage, or injury
caused by inappropriate handling or usage.
Quick Start Guide
FCC INFORMATION U.S.A.
1. IMPORTANT NOTICE: DO NOT MODIFY THIS
UNIT! This product, when installed as indicated in the instructions
contained in this manual, meets FCC requirements. Modifications
not expressly approved by Behringer may void your authority,
granted by the FCC, to use the product.
2. IMPORTANT: When connecting this product to
accessories and/or another product, use only high quality shielded
cables. Cables supplied with this product MUST be used. Follow all
installation instructions. Failure to follow instructions could void
your FCC authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply
with the requirements listed in FCC Regulations, Part 15 for
Class "B" digital devices. Compliance with these requirements
provides a reasonable level of assurance that your use of this
product in a residential environment will not result in harmful
interference with other electronic devices. This equipment
generates/uses radio frequencies and, if not installed and used
according to the instructions found in the users manual, may cause
interference harmful to the operation of other electronic devices.
Compliance with FCC regulations does not guarantee that
interference will not occur in all installations. If this product is found
to be the source of interference, which can be determined by turning
the unit "OFF" and "ON", please try to eliminate the problem by
using one of the following measures: Relocate either this product or
the device that is being affected by the interference. Utilize power
outlets that are on different branch circuits (circuit breaker or fuse)
or install AC line filters. In the case of radio or TV interference,
relocate/reorient the antenna. If the antenna uses 300 Ohm ribbon
cable, use coaxial cable instead. If these corrective measures do
not produce satisfactory results, please contact the local retailer
authorized to distribute this type of product. If you can not locate
the appropriate retailer, please contact Behringer customer service.
7
