Troy-Bilt 020242 Manual Del Propietário página 9

Ocultar thumbs Ver también para 020242:
Idiomas disponibles

Idiomas disponibles

Operation
HOWTO
USEYOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer heIpline at m -888-6 m m -6708.
Pressure
Washer
Location
Pressure
Washer
aearance
waRNING
1
Operate pressure washer ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate pressure washer inside any building or
encJosure,
The pressure washer must be at least 5 ft. (I 52 cm) from
structures
having combustible walls and/or other
combustible
materials. Leave at least 3 ft. (92 cm) all around
pressure washer including overhea& for adequate cooling,
maintenance and servicing.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially
occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventilation
intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 7). Prevailing winds and air currents should be taken
into consideration
when positioning
pressure washer.
/
/
/
/
Typical Pressu_ e
Washe_
Shown
Exhaust
Port
To Start
Pressure
Washer
To start your pressure
washer
for the first time, follow
these
instructions
step-by-step.This
starting
information
also applies if you have let the pressure
washer
sit idle for
at least a day.
I.
Place pressure
washer
near an outside
water
source
capable of supplying water
at a flow rate greater
than
3.8 gallons per minute
and no less than 20 PSI at
pressure
washer
end of garden
hose.
2.
Check that high pressure
hose is connected
to spray
gun and pump. See "Preparing
Pressure
Washer
for
Use" for illustrations.
3.
Hake sure unit is in a level position.
4.
Connect
garden
hose to water
inlet on pressure
washer
pump. Turn ON the
water.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5.
Squeeze trigger on gun until you have a steady stream
of water.This
purges the pump of air and impurities.
6.
Attach nozzle extension
to spray gun (Figure 8).
Tighten by hand.
Choose desired ProjectPro TMnozzle, pull back nozzle
extension
collar, insert nozzle and release collar.Tug on
nozzle to make sure it is securely in place (Figure 9).
See "How to Use ProjectPro TMNozzle System".
Engage trigger
loci< to spray gun trigger
(Figure
10).
Trigger Lock
loading