Troy-Bilt 020242 Manual Del Propietário página 10

Section 4: Operation
9.
Start engine according to instructions given in engine
owner's manuaLAHso see operating instructions tag
Hocated on the pressure washer.
WARNING
When starting engine, pulI cord slowiy until resistance is felt
and then pull rapidly to avoid kickback.
If engine starts and fMis to continue to run or if increased
resistance is fen during starting pull attempts, squeeze trigger
on spray gun.
NOTE: Always keep the throttle lever in the "Fast"
_osition when operating the pressure washer.
WARNING
DO NOT touch hot surfaces.
Allow equipment to coo[ before touching.
The pressure washer must be at [east 5 feet from structures
having combustible walls and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for" adequate cooling, maintenance and servicing.
In the State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code). Other
states may have similar laws. Federal laws applyon federal
lands. [f you equip the muffler with a spark arrester; it must be
maintained in effective working order:
How to Stop
Your Pressure Washer
I. Let engine idle for two minutes.
2. Turn engine off according to instructions given in
engine owner's manual.
3. Squeeze trigger on spray gun to relieve
trapped
pressure in hose to avoid iniuryo
NOTE: A small amount of water will squirt out when
pressure is released.
]
WARNING
Keep high pressure hose connected to pump and spray gun
while system is pressurize&
Squeeze trigger on spray gun to relieve trapped pressure,
every time you stop engine. Engage trigger lock on spray gun.
4. Engage trigger lockon spray gun when not in use.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your ProjectPro TM nozzles, spray gun and nozzle
extension.There is also a hook at the front of the
accessory tray to hold your high pressure hose.
NOTE:The extra hole in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo nozzle.The
brush and turbo nozzle are NOT included with your pressure
washer.You can buy these items as optional accessories.
I. Place nozzle extension through hole on accessory tray,
as shown in Figure II.
2. Place spray gun through hole on accessory tray on
right side of unit (Figure I I).
NOTE:You may also use the hooks attached to the base
and handle to store your gun and nozzle extension_ as
shown on page 5.
3. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown in Figure [ [.