Troy-Bilt 020242 Manual Del Propietário página 6

ASSENBL¥
mNPORTANT:
Read entire owner's manuaH before you
attempt to assembHeor operate your new pressure washer.
Remove Pressure 4asher from
Carton
o Remove the parts bag packed with pressure washer.
o Ske two corners at the end of carton from top to
bottom so the pane[ can be folded down fHat_ then
remove aHH p acHdng material
o RoHH pressure washer out of carton.
Carton Contents
Items in the carton include:
o HaHn Unit
Safety Goggles
HandHe
PHastk Accessory Tray
High Pressure Hose
Spray Gun
NozzHe Extension with Qu[cH<Connect Fitting
O[H Bottle
Parts Bag (whch [ncHudes the following):
Owner's HanuaH
Engine HanuaH
Owner's Registration Card
Bag containing 4 muHti-coHored PrqectPro TM
NozzHes
HandHe Fastening Hardware Kit (which incHudes):
Carriage BoHt
"U' BoHt (2)
PHastic Knobs (3)
Tree CHips (4)
PREPARING PRESSURE
WASHER FOR USE
If you have any probHems with the assembHy of your
pressure washer or if parts are missing or damaged_ caHH the
pressure washer heHpHine at i -888-6 i i -6708_
To prepare your pressure washer for operation, you
will need to perform these tasks:
H. Firth out and send in registration card.
2. Attach handHe to main unit_ then attach accessory tray
to handHe.
3. Add oiH to engine crankcase.
4. Add fueH to fueHtank.
5. Connect high pressure hose to spray gun and pump.
6. Connect water suppHy to pump.
7. Attach nozzHe extension to spray gun.
8. SeHect/attach quick connect ProiectPro TMnozzHe to
nozzHe extension.
Attach Handle and Accessory Tray
H. PHace handHe onto handHe supports connected to main
unit. Hake sure holies in handHe aHignwith holies on
handHe supports (Figure H).
HandHe
Align
NOTE: It may be necessary to move the handHe supports
from side to side in order to aHign the handHe so it wiHH sHide
over the handHe supports.
O