Craftsman 351.181770 Manual Del Operador página 4

Clavadora de acabado de angulo en linea
Idiomas disponibles

Idiomas disponibles

* Insert onenail s trip into the slotlocated ontheend ofthe
magazine.
Feed strip past n ail s top (see Figure 2).
ure 2 - Insert
Nail Strip
Slide
nail strip towards
the front of the magazine
until the
nail strip is in the nose (see
Figure 3).
Figure
3 - Slide
Nail Strip
Forward
Grasp
the pusher
housing
and pull it back until the pusher
is completely
behind
the nail strip. Then
release
the pusher
housing.
The housing
will travel forward
and the pusher
will
apply pressure
to the nail strip, pushing
it into the driving
mechanism
(see Figure
4).
Pusher
Figure
4 - Pull Pusher
Housing
Back and Release
NAILING
OPERATION
Refer to Figures
5-11 (pages
4, 5 and 6).
WARNING:
Read and follow
all safety rules
and operating
instructions
in this manual
and on warning
label of tool before
using this tool. Keep this manual
with the tool.
WARNING:
Do not use this tool without
safety
warning
label. If label is missing,
damaged
or unreadable,
contact
Sears
to obtain
a new label.
WARNING:
Never operate
tool unless
contact
trip is in con-
tact with workpiece.
Do not operate
tool without
fasteners
or
damage
to tool may result.
Never fire fasteners
into the air
because
fasteners
may injure operator
or others
and damage
to tool may result.
Perform
"Safety
Mechanism
Check"
as described
in the
Maintenance
section
(see
page 6) prior to first use of tool
and on a daily basis
thereafter.
The tool is equipped
with a rotating
switch
that can be set
to rapid-fire
or single-fire
mode
(see Figure
5). When
the
switch
is set to single-fire
mode,
the tool will not drive a
second
fastener
until the trigger
is fully
released
and
pulled
again.
When
the switch
is rotated
to rapid-fire
mode,
the tool can
drive fasteners
continuously.
A fastener
will be fired each
time the contact
trip is pressed
against
the workpiece,
as
long as the trigger
is maintained
in the pulled
position.
Figure
5 - Push and
Rotate
Switch
to Select
Operation
Mode
SINGLE-FIRE
OPERATION:
The air tool is equipped
with a contact
trip safety mecha-
nism that disables
tool unless
contact
trip is pushed
against
work. To drive a fastener
hold body firmly and
press
contact
trip on workpiece
where
fastener
is to be
applied.
Pull trigger
to drive fastener
into workpiece.
To fire
a second
fastener
lift the tool from the workpiece,
release
the trigger
and then
repeat the above
sequence.
RAPID-FIRE
OPERATION:
The tool can also be operated
by holding
trigger
depressed
and pushing
contact
trip against
workpiece.
A
fastener
will be driven
each time the contact
trip is pushed
against
the workpiece.
This operating
procedure
provides
rapid-fire
fastener
driving.
Never operate
tool unless
con-
tact trip is in contact
with workpiece.
4
loading