Idiomas disponibles
Idiomas disponibles
English
locking the rocker switch
The
rocker switch
CD
incorporates a transport
locking
system which prevents the switch from being
accidef'-
tally depressed, which action would result in unneces-
sary use of the battery.
The
switch is locked by
pushing
the locking butten @ down, and unlocked by
pressing
the
butten up.
lnserting the battery (Fig. 2)
•
Slide off the battery compartment lid
@.
•
Remove the terminal strip from
the
compartment
and
press it onto the poles of a 9
V
battery,
6F22 or
PP3
type.
The strip fits in one position only.
•
Push the batteryl4and
the
strip as illustrated into
the
c
ompartment; ensure
that
the strip in the compartment
·s
around the battery to facilitate its
removal.
•
Finally, refit the lid of the battery compartment.
Checking the battery voltage
For a correct working of the machine, it is
necessar,
that the battery is in good condition.
Therefore,
it is
re-
commended to check the battery voltage from lime
to
lime,
especially after intensive use of the machine.
T o
do this, push
the top of the rocker switch
CD
inwards
and pull
control
®
downwards.
If
the battery voltage is
still
sufficient,
a buzzing sound will be audible.
If this
is
not the case,
the battery must be replaced.
If
the battery is
exhausted or if the machine is not to
be
used for a longer
period,
remove the battery in order
to
prevent damage due to possible battery leakage.
4
lnserting
and removing the cassette
Each
side
of
a
LFH
0002 cassette will play
for
15 mins.
i.e.
30 mins. in
total.
For
identification,
one side of the
cassette is marked with one dot and the ether side with
two dots. When
one side is full (the
left-hand reel is
then
empty), the cassette may be turned over
to
continue on
the ether side.
N.B.
The
cassette may
be turned
over
whenever desired, there is no need to wait until the
end
of the tape is reached.
Since
the cassette weighs only
11
grams, it can
be
mailed without difficulty by letter post.
lnserting
the cassette (Fig. 3)
•
Hold
the cassette compartment
lid
®
at the bottom
and slide the
lid
downwards until the initial stop.
•
lnsert the
cassette with
the
full
reel
on
the left. Hold
it
by
its sides,
press the
open cassei,e
front
against
the
pressure
springs which are beneath
the lid
(A) and
gently push the
cassette over
the
two spindles (B).
•
Close
the lid.
Removing
the
cassette
•
Open the
cassette compartment
lid
®
until
the
initial
stop.
•
Lift the
cassette at the sides and take it out of the
cassette compartment.
•
Close the lid.
5
