Idiomas disponibles
Idiomas disponibles
English
Symptom
Tool suddenly stopped
Cannot be inclined
Cannot reverse incline
Parallelism cannot be fine tuned
Doesn't cut well
Switch can't be pulled
Sawdust discharge is poor
Battery cannot be installed.
Possible cause
The battery is overheated.
The incline lever and incline wing nut
are not loosened.
The cutting depth is set at maximum.
The incline lever and incline wing nut
are not loosened.
The M6 fastening screws (×2) are not
loosened. (See 21 in Fig. 11 )
The saw blade is worn or missing
teeth.
The bolt is loose.
The saw blade is installed
backwards.
The switch lock is not pushed in
enough.
Sawdust has accumulated in the saw
cover.
Attempting to install a battery other
than that specified for the tool.
20
Remedy
Let the battery cool down.
Try inclining after loosening the
incline lever and incline wing nut.
Tighten the loosened parts after
making the necessary adjustments.
Reverse incline after adjusting the
cutting depth to a lesser setting.
Try inclining after loosening the
incline lever and incline wing nut.
Loosen each of the M6 fastening
screws (×2).
Replace with a new saw blade.
Firmly tighten the bolt.
Install the saw blade in the proper
direction.
Push the switch lock in all the way.
Remove the sawdust inside the saw
cover.
Please install a multi volt type battery.
