Screen Messages - ZUMEX ESSENTIAL BASIC Manual De Usuario

DETECTING FAULTS
FAULT POSSIBLE CAUSE
THE MACHINE DOESN'T Machine not plugged in.
WORK
No power is reaching the plug.
Cover not fitted properly.
Juice container not fitted properly.
Blocked pressing units.
Safety sensors malfunctioning.
Faulty ON/OFF button.
Faulty circuit.
THE MACHINE BLOCKS Insufficient voltage.
FREQUENTLY DURING
JUICING
Faulty circuit.
THE PRESSING UNITS ARE Fault in an axle.
NOT SYNCHRONIZED
PEEL EJECTOR BREAKS Peel ejector incorrectly fitted.
YOU CAN HEAR THE MOTOR Internal fault.
RUNNING BUT THE PRESSING
UNITS ARE NOT TURNING
THE FAUCET GETS BLOCKED The juice has seeds or too much
pulp.
CORRECTION
Plug it in.
Check the socket.
Make sure it has been fit properly.
Make sure it has been fit properly.
Turn off the machine at the mains
and unblock the pressing units.
Contact your technical service.
Contact your technical service.
Contact your technical service.
Check that the voltage matches
that indicated in the manual.
Contact your technical service.
Contact your technical service.
Place it in its correct position
inserting it totally until observing it
has madecontact (Fig. 8)
Contact your technical service.
Disassemble and clean the faucet
according Fig. 11A.
FAULT POSSIBLE CAUSE
THE MACHINE STOPS EVERY Insufficient ventilation.
NOW AND AGAIN
Overload.
SCREEN DOES NOT DISPLAY Alteration to mains systems.
INFORMATION
THE MACHINE IS IN SELF- Faucet not fitted or fitted
SERVICE MODE AND WON'T incorrectly.
STOP OPERATING
Faucet well fitted: possible internal
fault.
Faucet block activated.
WARNING: Any action to unblock the machine must be carried out by disconnecting it
from the mains. If, after making the checks stated here, the machine does not work, call the
technical service.

SCREEN MESSAGES

DISPLAY MESSAGE CAUSE
EXCESS CURRENT The maximum electrical
consumption level has been
exceeded for at least one second.
NO ORANGES The motor remains on for two
minutes detecting any squeezing.
MEMORY INITIATED A memory error has been detected.
CALIBRATION An incorrect calibration value has
been detected.
CORRECTION
Check that the appliance's
ventilation grilles are not blocked.
Contact your technical service.
Turn off the machine and turn it
back on again.
Fit the faucet in the manner
indicated in Fig. 11A
Contact your technical service.
Put the block in horizontal position
by pressing the faucet downwards.
CORRECTION
Turn off at mains and turn back
on again.
Put oranges back in feeder again
without and press ON.
Contact your technical service.
Calibrate (See page 18).
49