Idiomas disponibles
Idiomas disponibles
¶ When using the speakers in a room with permeable
walls, place the speakers as closely as possible along
the walls, or install them in front of a screen or other
object with reflective properties.
¶ When used with a television, the speakers should be
installed so that their front surfaces are in the same
plane as the screen of the television.
¶ When using the speakers with a television screen, the
optimum breadth of sound will be produced when the
television screen is placed midway between the right
and left speakers, and the speakers are oriented at
angles of about 50–60° from the listening position.
¶ In rooms with hard reflective or resonating walls, it may
be desirable to cover the walls with a curtain, and/or
place a carpet on the floor to dampen excessive sound
reflection. Extending the curtain all the way to the
corners will help prevent local deadening of the sound.
On the other hand, if the wall opposite the speakers
(behind the listening position) is also composed of a
hard surface, placing a thick curtain over the wall will
help prevent the production of standing waves, and
result in better sound.
Installation Precautions
¶ These speaker systems are heavy; installing them in
unstable locations is extremely dangerous and should
be avoided.
Connection to Amplifier
Terminals are provided at the bottom of the speakers for
connection to an amplifier.
1 Disconnect the power cord to the amplifier.
2 Use the provided accessory speaker wires to connect
the input terminals at the bottom of the speakers to the
amplifier's speaker output terminals.
Connect the ª terminal to the wire with the white line;
connect the · terminal to the solid-color wire.
1. Remove insulation at end of wire and twist
ends of wire strands.
2. Insert speaker wire through hole in the
bottom of the speaker stand.
3. Loosen the screws, pass the wire cores
through the terminal holes, and retighten
the screws thoroughly.
Black ·
Connect solid-color wire to
amplifier's · speaker output
terminal.
4. Remove the protective backing paper from
the hook-and-loop fastener strip (hook strip),
and apply to the bottom of the speaker stand
near the rim depression for the speaker wire
(see illustration).
5. Pass the speaker wire through the rim
depression as shown.
6. Place the other hook-and-loop fastener strip
(loop strip) onto the first strip (hook) with
the speaker wire passing between the two
strips, so as to fix the speaker wire in
position.
Rim depression
Hook-and-loop
for speaker
fastener strip
wire.
(loop)
Place loop
strip over
wire and
onto hook
strip.
¶ After connecting the wires to terminals, pull gently on
the wire and confirm that the wire lead is fastened
securely to its terminal. Insecure connections will
result in broken sound and noise.
¶ Do not allow bare wire ends to protrude excessively
from the terminals. If the bare wires from the two leads
touch each other, excessive load will be placed on the
amplifier, leading to possible damage or malfunction.
¶ Be sure to connect the + and – leads to their correct
terminals. If the poles at one end of the wires are
connected mistakenly (+ to –, – to +), proper stereo
effect will not be produced.
Red ª
Connect wire with white
line to amplifier's ª
speaker output terminal.
Hook-and-loop
fastener strip (hook)
3
En
