Idiomas disponibles
Idiomas disponibles
ADJUSTING
HOLDDOWN
Disconnect
machine
from
power
source.
The holddown
(A) Fig. 15, should
be adjusted
so
it contacts
the top surface of the work (D) being cut.
Loosen lock knob (B) and move holddown rod (C) up or
down, then tighten lock knob (B). The holddown (A) Fig.
15, may be adjusted front to rear, by loosening set screw
(B) Fig. 16, and positioning the holddown
in the desired
location. Once the holddown
is in the desired location,
tighten set screw (B), Fig. 16.
ADJUSTING
DUST BLOWER
The dust blower (A) Fig. 16, may be positioned to direct
air to the most effective point on the workpiece.
DUST COLLECTION
CUP
A dust collection
cup (A) Fig. 17 is provided
and can
be attached
to a vacuum system by utilizing the port
covered by cap (B).
13
