into the DC 12V cigarette lighter socket of the car or ship to charge for the product,
as shown in Figure 2 and Figure 3.
（Figure 2）
Inflation Operation
1. Long press the switch to enter the stand-by state.
2. Connect the end with the flexible conduit adaptor of the hose and the inflation
inlet of the air pump, and twist clockwise to tighten it, as shown in Figure 5.
3. Connect the other end of the hose with the air nozzle that matches the air bag,
and insert the inflation valve of the air bag. Turn it clockwise to fix it, as shown in
Figure 6.
4. Press the pressure unit switching button
5. Press the pressure increase button
the desired pressure value. The pressure range is from 0 to 16 PSI. (1 PSI=0.0689
bar=6.89KPA)
5
（Figure 3）
（Figure 5）
（Figure 6）
and select the unit you need.
or pressure reduction button
6. Press the power on/off button
7. In the process of inflation, you can press the pressure increase button
pressure reduction button
the pressure unit switching button
the power on/off button
8. When the pressure reaches the set value, the air pump will stop inflating
automatically.
9. Upon the completion of inflation, it will automatically be off within 2 minutes.
10. After pulling out the DC plug, please take down the hose from the air pump and
air bag for easy storage.
Note: The factory set pressure valve of the air pump is 10PSI (10PSI=0.689BAR). At
the second use, the set pressure value for the last time use will be displayed by
default.
Deflation Operation
1. Remove the hose from the inflation inlet. Connect the end with the flexible
conduit adaptor of the hose and the air pump deflation outlet. Twist it clockwise
to tighten it, as shown in Figure 7 and the other end shall still be to the airbag.
2. Press the power switch button of the air pump and start the deflation until all the
gas is discharged. Then turn off the power to stop the deflation.
to set
to start inflation.
to increase or decrease the pressure value. Press
to switch between the units, and press
to stop inflation.
（Figure 7）
or
6
