AYR 758 Manual Del Usuario página 19

2. Installing the device on the door
2.1 Before Installation
Before installation, unscrew the mounting plate on the underside
of the visor and remove the adhesive protector.
Make sure that the thickness of the door where the peephole
goes is the correct thickness. Please note that some doors have
a different thickness in the middle than the rest of the door.
2.2 Installation
1. Remove the conventional door viewer or drill a 14 mm hole at
the desired height. Peel off the 3M sticker from the back of the
doorbell and insert it from the outside, making sure that the posi-
tion is correct. Attention: It is very important that you peel off the
sticker so that the camera is perfectly fixed to the door (FIG.1).
2. Place the bracket on the end of the camera. Screw the moun-
ting tube onto the threaded sleeve of the camera and tighten it.
Secure the socket tightly with the enclosed tightening tool. Make
sure that the arrow on the bracket points upwards (FIG.2).
19
FIG. 1
EN
FIG. 2