MTD 450 Serie Manual Del Operador página 8

2. Remove the hex lock nut, spacers, and hex bolt from the
top of the impeller housing. See Fig. 3-3B.
3. Align the chute deflector in position on the discharge
opening and insert hex bolt with spacer through hinge on
chute deflector (spacers fit inside of hinges). See Fig. 3-4A.
r
k. j
Figure 3-4
4. Place second spacer over hex bolt inside other hinge and
secure with hex lock nut. See Fig. 3-4B.
5. Secure both sides of chute deflector to impeller housing
using wing knobs previously removed. See Fig. 3-4C.
Chipper C hute (Model Series 460)
1. Remove the three cupped washers and hex nuts from
weld studs around the opening on the side of the impeller
housing. See Fig. 3-5A.
F
f
Figure 3-5
2.
Remove the hex bolts, flat washers, and lock nuts from the
two holes on the upper end of the support brace. See Fig.
3-5B.
3. Align the chipper chute over the weld studs, so the slot in
the bottom of the chute is facing down. See Fig. 3-6A.
/ /
/
/
/ /
/
/
/7
i /
,/1
/
/
sI
Figure 3-6
8
I
SECTION 3
-- ASSEMBLY & SET-UP