Starting / Stopping The Engine - Stihl FC-MM Manual De Instrucciones

1
3
The axle (1) must be below the shaft (2).
Direction of rotation (3) of MultiTool.
Adjusting Position of Gearbox
Loosen clamp screws on gearbox.
N
Turn the gearbox through 180°.
N
Line up the gearbox in the correct
N
position.
Tighten down the two clamp screws
N
on the gearbox in the following
sequence:
Tighten the first screw moderately.
–
Tighten the second screw
–
moderately.
Tighten down first screw firmly.
–
Tighten down second screw firmly.
–
FC-MM
NOTICE
2
It must not be possible to rotate the
gearbox on the drive tube.
Mounting the MultiTool
The direction of rotation is marked with
arrows on the gearbox and cutting
blade. Make sure the arrows point in the
same direction.
8
4
5
Fit the two sleeves (4) on the right
N
and left.
Rotate the blade (5) on the right-
N
hand axle (viewed from engine) until
it can be pushed into position –
check the direction of rotation again
(arrows).
Push the wheel (6) and washer (7)
N
onto the left-hand axle (viewed from
engine).
Insert and engage both hitch
N
pins (8) in the holes in the axles –
fold the hitch pins flat against the
blade and wheel.
Starting / Stopping the
Engine
Starting the Engine
Always follow the starting procedure
described in the MultiEngine instruction
manual.
8
6
4
7
Secure the handlebar in the normal
N
operating position.
Retract the wheels, if fitted – see
N
chapter on "Wheels" in MultiEngine
instruction manual.
Retract the spur, if fitted.
N
English
11