Idiomas disponibles
Idiomas disponibles
ADDITIONAL SAFETY PRECAUTIONS
CAUTION
•
Know the pump applications, limitations, and potential hazards.
•
Make certain the electrical power source is adequate for the requirements of the pump.
•
ALWAYS disconnect the power to the pump and drain all water from the system before
servicing.
Secure the pump on a solid base to keep the pump vertical and above mud and sand
•
during operation to maximize pumping efficiency and prevent clogging and premature
pump failure.
Secure the discharge hose before starting the pump. Pump torque may cause an unsecured
•
discharge hose to "whip", possibly causing personal injury and/or property damage.
•
Before using the pump, check hose for holes or excess wear, which could cause leaks,
and be sure hose is not kinked or making sharp angles. A straight hose allows the pump to
move the greatest amount of water quickly.
Check that all hoses connections are tight to minimize leaks.
•
•
Connect the pump DIRECTLY to a grounded, GFCI outlet.
•
Extension cords may not deliver sufficient voltage to the pump motor. Extension cords
present a life-threatening safety hazard if the insulation becomes damaged or the
connection ends fall into water.
•
Make certain the electrical circuit to the pump is protected by a 10-amp or larger fuse or
circuit breaker.
•
Periodically inspect pump and system components, to be sure pump inlets are free of
mud,sand and debris. DISCONNECT PUMP FROM THE POWER SUPPLY BEFORE
INSPECTING.
•
Wear safety glasses at all times when working with pumps.
Follow all electrical and safety codes, particularly the National Electrical Code (NEC) and
•
in the workplace, the Occupational Safety and Health Act (OSHA).
•
This unit is designed only for use on 115 volts (single phase), 60 Hz, and is equipped with
an approved 3-conductor cord and 3-prong grounded plug. DO NOT REMOVE THE
GROUND PIN UNDER ANY CIRCUMSTANCES. The 3-prong plug must be directly
inserted into a properly installed and grounded 3-prong, grounding-type receptacle.
Do not use pump with a 2-prong wall outlet. Replace the 2-prong outlet with a properly
grounded 3-prong receptacle (a GFCI outlet) installed in accordance with the National
Electrical Code and local codes and ordinances. All wiring should be performed by a
qualified electrician.
•
Protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid
kinking the cord. Do not use damaged or worn cords.
11
