LEGRAND C2G Manual página 7

HDMI® HDBaseT + USB-B to A and RS232 over Cat Extender Box Transmitter to
Box Receiver (18Gbps) - 4K 60Hz up to 328ft
Wiring
Warnings:
Before wiring, disconnect the power from all devices.
•
During wiring, connect and disconnect the cables gently.
•
Steps for device wiring:
1. Connect an HDMI source (such as PC, Blu-ray player, Apple TV, 4K media
player, etc) to the HDMI IN of the transmitter using an HDMI cable.
2. Connect a Cat 5e/6/6a/7 cable between the HDBT OUT of the
Transmitter to the HDBT IN Input of the Receiver.
3. Connect an audio source to AUDIO IN (PASS-THROUGH) port of the
transmitter, and connect an audio receiver to AUDIO OUT (PASS-
THROUGH) port of the receiver.
4. Connect a USB Host device to USB HOST port of the Transmitter, and
connect USB devices (such as keyboard, mouse and USB camera) to USB
DEVICE ports of the Receiver. The USB devices can be connected to the
Host PC.
5. Connect for additional control options:
Ethernet pass-through: Connect a PC to ETHERNET port of the
•
transmitter/receiver, and connect a network to ETHERNET port of the
receiver/transmitter, then the PC can be connected to the network.
RS232 operations: Connect a control PC or control system to RS232
•
port of the transmitter and receiver. Use the DIP switch to set the
function of RS232 port, see "DIP Switch Settings" section.
Audio de-embedding output: Connect audio receivers to AUDIO OUT
•
(DE-EMBED) ports of the transmitter and receiver for de-embedding
audio output.
7. Connect the included 12V power supply to the Receiver. With one-way
PoH function supported, one power adapter is needed to connect to the
receiver to power both units.
8. Power on all attached devices.
5
(us)
(us)