LEGRAND C2G Manual página 4

HDMI® HDBaseT + USB-B to A and RS232 over Cat Extender Box Transmitter to
Box Receiver (18Gbps) - 4K 60Hz up to 328ft
Product Overview
Front Panel
Transmitter
① ② ③ ④ ⑤
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 P LED
OWER
Off: No power is applied to the device.
On: HDBT link is normal.
2 L LED
INK
Off: No HDBT link or link error.
On: HDMI input signal is active.
3 V LED
IDEO
Off: No HDMI input signal or HDMI input signal is inactive.
4-Pin DIP Switch for settings of RS232 working mode (RS232
pass-through, Valens firmware upgrade and MCU firmware
4 SET
upgrade). For more information, see "DIP Switch Settings"
section.
Connect to an audio source for audio pass-through from
AUDIO IN
5
transmitter to receiver.
(PASS THROUGH)
6 USB-B H USB 2.0 Type-B port. Connect to a USB host device (e.g., PC).
OST
⑥
Rear Panel
⑦ ⑧
R P D
EAR ANEL ESCRIPTION
Connect to the power adapter provided. With one-way PoH
7 DC 12V function supported, one power adapter is needed to connect
to the receiver to power both units.
Connect to a RS232 device for bi-directional RS232 pass-
8 RS232
through or firmware upgrade.
9 HDBT OUT Connect to HDBT IN port of receiver.
10 HDMI IN Connect to an HDMI source using an HDMI cable.
AUDIO OUT
Connect to an audio receiver (e.g., speaker) for audio de-
11
embedding output.
(DE-EMBED)
12 ETHERNET Connect to a network or a PC for ethernet pass-through.
2
Transmitter
⑨ ⑩ ⑪
(us)
(us)
⑫