Cleaning And Care; Cleaning The Air Filter - Friedrich MW09C1F Manual De Funcionamiento

CLEANING AND CARE

Before cleaning the plasma filter unit, be sure to turn off the power supply to the air conditioner.
WARNING!
Electric shock may result.
G Make sure the plasma filter unit is properly mounted before cleaning or performing other tasks
CAUTION!
on it. If the unit is not properly mounted, it could fall off and cause damage or injury.
G You can be injured if you touch the heat exchanger when removing or installing the plasma filter
unit. Do not insert your fingers between the plasma filter unit and the heat exchanger.
Cleaning the Intake Grille
1. Remove the Intake Grille.
1 Place your fingers at both lower ends of the grille
panel, and lift forward; if the grille seems to catch
partway through its movement, continue lifting up-
ward to remove.
2 Pull past the intermediate catch and open the Intake
Grill wide so that it become horizontal.
Intake Grille
2. Clean with water.
Remove dust with a vacuum cleaner; wipe the unit with
warm water, then dry with a clean, soft cloth.
3. Replace the Intake Grille.
1 Pull the knobs all the way.
2 Hold the grille horizontal and set the left and right
mounting shafts into the bearings at the top of the
panel.
Intake Grille
Intake Grille
G When used for extended periods, the unit may accumulate dirt inside, reducing its performance. We recommend that the
unit be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service
personnel.
G When cleaning the unit's body, do not use water hotter than 108 °F , harsh abrasive cleansers, or volatile agents like
benzene or thinner.
G Do not expose the unit body to liquid insecticides or hairsprays.
G When shutting down the unit for one month or more, first allow the fan mode to operate continuously for about one-half
day to allow internal parts to dry thoroughly.
En-11
1. Open the Intake Grille, and remove the air
Intake Grille
2. Remove dust with a vacuum cleaner or
Mounting
shaft
3. Replace the Air Filter and close the Intake
Knob
Mounting shaft
(For purposes of example, the illustration shows the unit
Bearing
without Intake Grille installed.)
G Dust can be cleaned from the Air Filter either with a
Knob
G If dirt is allowed to accumulate on the Air Filter, air flow
Mounting
shaft
G During periods of normal use, the Air Filters should be
Knob

Cleaning the Air Filter

filter.
Lift up the air filter's handle, disconnect the two lower
tabs, and pull out.
Air filter handle
by washing.
After washing, allow to dry thoroughly in a shaded place.
Grille.
1 Align the sides of the Air Filter with the panel, and
push in fully, making sure the two lower tabs are re-
turned properly to their holes in the panel.
2 Close the Intake Grille.
vacuum cleaner, or by washing the filter in a solution of
mild detergent and warm water. If you wash the filter, be
sure to allow it to dry thoroughly in a shady place before
reinstalling.
will be reduced, lowering operating efficiency and in-
creasing noise.
cleaned every two weeks.
Air filter handle