Idiomas disponibles
Idiomas disponibles
TO CLEAN:
1. Open the lid of reservoir, and pull out the
water filter (Fig. 8).
2. Pour white vinegar into water reservoir up to
the 6-cup level shown in the reservoir's window.
3. Add cold water up to the 12-cup line.
4. Put a paper filter in the brew basket, close door,
and place empty carafe on the warming plate.
5. Turn ON the coffeemaker and let half of the
vinegar water solution brew through into carafe.
6. Turn the coffeemaker OFF at this point and let
it soak for at least 15 minutes to soften any deposits.
7. Turn the coffeemaker back ON and brew the
remaining solution into the carafe. When brew
cycle has stopped, turn OFF coffeemaker,
empty carafe, and discard soiled paper filter.
8. Refill reservoir with cold water and turn ON to
run another brew cycle. You may want to repeat
again to eliminate any vinegar smell/taste.
9. Wash the brew basket and carafe.
I
TO CHANGE THE CHARCOAL
WATER FILTER:
.
2.
.
Remove
new filter from wrapping and soak in cold tap water for 15 minutes.
Grasp the water filter holder's stem in one hand, with the word Open facing up.
Using the thumb of the other hand, gently press down and pull toward you
(see Fig. 9). Compartment will flip open.
Place the filter in the holder and close
the water filter holder; you will hear a
snap indicating the filter is in place.
NOTE:
Use caution
when inserting
the new water
filter so that the filter
skin does
not tear.
Fig. 9 _
f_
,
.
Hold the filter under cold running
tap water to flush,
being sure to have the hole
openings
in the unit directly
under the water stream.
Allow water to drain from
filter completely.
Place the new charcoal
water filter into the water
reservoir,
pushing
it all the
way down into the base. Coffeemaker
is cleaned
and ready for use.
To remove
the Clean
Filter icon in the Control
Panel Display,
push the Strength
and 2 - 12 Cup buttons
simultaneously.
10
