Whirlpool 4GWED5500 Instrucciones De Instalación página 8

INSTALL LEVELING LEGS
1.
Prepare dryer for leveling legs
To avoid damaging floor, use a large flat piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
2.
Screw in leveling legs
diamond
marking
Examine leveling legs to find diamond marking. Screw legs
into leg holes by hand; use a wrench to finish turning legs
until diamond marking is no longer visible.
Now stand the dryer on its feet. Slide the dryer until it is
close to its final location. Leave enough room for electrical
connection and to connect the exhaust vent.
8
ELECTRICAL CONNECTION
Electrical Connection Options
1.
Choose electrical connection type
Power supply cord: Go to steps 1–2 on
page 9 for power supply cord strain relief,
then steps 3–5 in "Power Supply Cord Con-
nection" section. Then go to the "Venting
Requirements" section.
Direct wire connection: Go to steps 1–2
on page 9 for direct wire strain relief, then
steps 3–7 in "Direct Wire Connection"
section. Then go to the "Venting
Requirements" section.
2.
Remove terminal block cover
C
B
Before you start, disconnect power. Remove hold-down
screw (D) and terminal block cover (A).
A. Terminal block cover
B. External ground conductor screw
C. Center terminal block screw
D. Hold-down screw
E. Neutral ground wire
F. Hole below terminal block cover
A
D
E
F