Idiomas disponibles
Idiomas disponibles
When setting both the main and sub remote controllers
Regarding the contents of the installation, please scan the matrix two-dimensional (2D) barcode and refer to
the detailed manuals.
After installation, set one remote controller to [Main] and the other to [Sub] for [Main/sub] for "Setting".
When using the remote controllers* in combination, set the CZ-RTC6(CZ-RTC6W) unit to [Sub].
*CZ-RTC5B, CZ-RTC6BL(CZ-RTC6WBL)
Note
Remote controllers can be connected to any indoor unit for operation.
Mounting
1
Remove the top case.
Insert the screwdriver to the bottom case.
1
Insert the fl at-blade screwdriver to the claws as show in
the fi gure.
A
Top case
Bottom case
2
Mount to the wall.
There are 2 types of wall-mounting methods: Exposed type and Embedded type.
Attention
Mounting the bottom case
Tighten the screws securely until the screw heads touch the bottom
case.
(Otherwise, loose screw heads may hit the PCB and cause
malfunction when mounting the top case.)
Do not over-tighten the screws.
(The bottom case may be deformed, resulting in the unit becoming
detached from the surface it is fixed to.)
Connection to the remote controller terminal board
Depress the push button using a round bar or fi nger, insert the
remote control wiring securely from the wiring insertion slot and
release the push button.
Pull the remote control wiring lightly, and confi rm it is secured.
There is the danger of shorting if copper wire is exposed. Make sure
the wire is properly inserted.
6
Flat-blade screwdriver
Claw (2 locations)
Push the fl at-blade screwdriver in.
2
Push down the fl at-blade screwdriver along with the
slope of the claws until the top case comes off .
View A
Top case
Bottom case
Flat-blade screwdriver
Claw
Insertion slot
Remote controller terminal board
Push button
