Idiomas disponibles
Idiomas disponibles
Checking
for LP gas leaks.
Never test for leaks with a flame. Prior to first use, at
the beginning of each season, or every time your LP
gas tank is changed, you must check for gas leaks.
1. Make a 50/50 mild soap solution.
2. Turn the control knobs to full OFF position; then
turn gas ON at supply tank.
3. Apply the soap solution with a clean brush to all
gas connections. See below. If growing bubbles
appear in the solution the connections are not
properly sealed. Check each fitting and tighten or
repair as necessary.
Gas Connection Leak Check
4. If you have a gas connection leak you cannot
repair, turn gas OFF at supply tank, disconnect
fuel line from your grill and call 1-800-4-MY-HOME
or your gas supplier for repair assistance.
5. Also apply soapy solution to the tank seams. See
below. If growing bubbles appear, shut tank OFF
and do not use or move it! Contact an LP gas
supplier or your fire department for assistance.
Gas Tank Leak Check
Grill Lighting Instructions for Main Burners
1. Do not smoke while lighting grill or checking gas
supply connections.
2. Be sure that LP gas tank is sufficiently full.
3.
Be sure all gas connections are securely
tightened.
4 Open the grill main lid and side burner lid.
5.
Push and turn any main burner knob to _ HI
position, holding for 3 to 5 seconds until burner
ignites.
6. To light additional burners, push and turn
burner knob(s) to _
HI until burner(s) ignites,
then adjust knob(s) to desired setting.
/'_
WARNING
Failure to open grill lid during the lighting
procedure could result in a fire or explosion
that could cause serious bodily injury, death,
or property damage.
7. If the burner does not light after 5 seconds, turn
knob to OFF. Turn gas OFF at LP tank and wait 5
minutes for gas to clear. Then turn gas ON at
tank and repeat step 5.
8. If burner still does not light, see Match Lighting
section and If Grill Still Fails to Light section on
following page.
LIGHTING INSTRUCTIONS
FOR ROTISSERIE
BURNER
1. Open lid during lighting.
2. To ignite, turn rotisserie knob to _ ON, hold for 3 to
5 seconds until burner ignites. If ignition does not
occur in 5 seconds, turn knob to OFF, wait 5
minutes and repeat the lighting procedure.
3. Important: When using the Rotisserie Burner, do not
use the Main Burners.
4. If burner still does not light, see Match Lighting
section and If Grill Still Fails to Light Section on
following page.
USING THE SIDE BURNER:
Inspect the gas supply hose prior to turning the gas
"ON". If there is evidence of cuts, wear or abrasion,
it must be replaced prior to use. Do not use the
side burner if the odor of gas is present.
WARNING: Always
keep your face and body as
far away from the burner as possible
when
lighting.
LIGHTING INSTRUCTIONS
FOR SIDE BURNER
1. Open side burner lid fully.
2. Push and turn side burner knob to _ ON
position, holding for 3 to 5 seconds until burner
ignites.
3. If the side burner does not light after 5 seconds,
turn knob to OFF, turn gas OFF at LP tank and
wait 5 minutes for gas to clear. Then turn gas ON
at tank and repeat step 2.
4. If burner still does not light, see Match Lighting
section and If Grill Still Fails to Light section on
following page.
8
_.I
WARNING
Never lean over the grill cooking area while lighting
your gas grill. Keep your face and body a safe
distance (at least 18 inches) from the cooking grid
surface when lighting your grill by match.
