Idiomas disponibles
Idiomas disponibles
tem outer foil to dry completely.
Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year and
the inner blades at least every two
years to maintain your shaver's cut¬
ting performance.
Replacing the system outer foil
(see fig. 7)
Squeeze the system outer foil re¬
lease buttons and lift the system
outer foil upward to remove it. To in¬
sert the new system outer foil, press
down until it snaps into place.
Replacing the inner blades
(see fig. 8)
Squeeze the foil frame release but¬
tons and lift the foil frame upward to
remove it. Remove the inner blades,
one at a time, by grasping them firmly
at both ends and pulling straight
away from the shaver. To insert the
new inner blades, hold the blades,
one at a time, at both ends and press
downward until they snap into place.
ATTENTION:
A nickel cadmium battery that is
recyclable powers the product
you have purchased. At the end
of it's useful life, under various
state and local laws, it is illegal
to dispose of this battery into your
municipal waste stream. Please
call 1-800-8-BATTERY for infor¬
mation on how to recycle this
battery.
How to remove the built-in re¬
chargeable battery
(see fig. 9)
The procedure described below is
intended only for removal of the re¬
chargeable battery for the purpose
of proper disposal.
WARNING:
Do not attempt to replace the built-
in, rechargeable batteries yourself
for the purpose of reusing the
shaver.This could result in the risk
of fire or electric shock. Please
contact your nearest authorized
Panasonic service center.
1. Remove the cap, outer foil frame
and inner blades.
2. Remove the two screws (b) and
driving bars (a).
3. Remove two screws (c) and bot¬
tom cover (d).
4. Push the chassis out of the hous¬
ing.
5. Remove the batteries from the
chassis.
Caution
• Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
• Use only the included shaver
charging adaptor RE3-88 to charge
8
