Replacing The Power Cable; Maintenance And Cleaning; Ordering Replacement Parts; Disposal And Recycling - EINHELL WW 2000 R Manual De Instrucciones

While the Switch-on time / Switch-off time is
fl ashing in the display, set the hours / minutes by
pressing the + / - buttons.
When the switch-off time has elapsed, „End" is
shown in the display and the heater switches off .
6.5 Overheating guard
In case of excessive heating the equipment will
shut down automatically. If this occurs, turn off the
equipment, disconnect the mains plug and wait
a few minutes for the equipment to cool. After eli-
minating the cause (e.g. a covered air grille), the
equipment can be switched on again.
6.6 Topple cut-out
NOTE! The equipment has a topple cut-out. If the
equipment is tilted beyond a certain angle, it will
be deactivated automatically and only restarted
after it has been returned to its upright position
(standby).

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.

8. Maintenance and cleaning

Danger!
•
Before carrying out any cleaning and main-
tenance work the equipment must be turned
off, disconnected from the power supply and
cooled down.
•
Maintenance and repair work may only be
carried out by an authorized electrical servi-
cing contractor or ISC GmbH.
•
Check the power cable at regular intervals
for signs of defects or damage. A damaged
power cable may be replaced only by an elec-
trician or ISC GmbH in compliance with the
relevant regulations.
•
Use a damp cloth to clean the casing.
•
Remove dust with a vacuum cleaner.
Anl_WW_2000_R_SPK7.indb 16 Anl_WW_2000_R_SPK7.indb 16
GB

9. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

10. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
11. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 16 -
13.03.15 09:34 13.03.15 09:34