Idiomas disponibles
Idiomas disponibles
Assembly
WARNING:
• When assembling or inserting the extraction filter
as well as the carbon filter, the appliance must not
be connected to the mains.
• Failure to use the mounting fixtures may lead to a
risk of electric shock.
CAUTION:
• Before mounting, check that the wall has enough
load capacity to bear the cooker hood.
• When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
• Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE: Recommendations for preparation work
• When installing, ask another person to assist.
• Wear protective gloves to prevent injuries from
any sharp edges.
Drilling dimensions
[03]
unit mm
[04]
[05]
• Determine the position of the cooker hood central-
ly above the cooking area in accordance with the
specified safety distances.
Totally 9x mounting holes with a diameter of approx.
8 mm are necessary for the wall mounting. Insert the
supplied dowels [08].
Mark the holes required for wall mounting as
•
shown in the drawing. First specify the extension
length of the shaft cover for the position of the
bracket [04] at the upper shaft end. Check the
markings with a spirit level!
• Fix the bracket [05] for the housing with three
screws ST4x30mm [09] and the brackets [03] and
[04] at the pre-marked positions, each with two
screws ST4x30mm [09].
• Before inserting the hood, affix the non-return
valves [07] by gently bending them from above
onto the exhaust duct.
64
