Idiomas disponibles
Idiomas disponibles
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
"Cleaning and Maintenance"
according to chapter
Appliance Equipment
Appliance overview
1 Shaft unit
4 Aluminum grease filter
2 Housing
5 Glass front (grease filter
3 Motor unit
Delivery scope
1x aluminum grease filter, 1x 2-part chimney shaft,
1x exhaust hose, 2x non-return valve,
tion material
Installation
The cooker hood is only intended to be installed
over a hob with no more than four hob elements
There must be a safety distance between the hot-
plate of the cooking pot on the hob and the bottom
part of the cooker hood:
The distance must be between 65 – 75 cm. For gas
appliances, the distance must be at least 65 cm.
If the installation instructions for the gas cooker spec-
ify a greater distance, this distance must be taken
into consideration.
cover)
incl. Installa-
Selecting the fume outlet
You can operate the cooker hood in two modes:
Extraction mode
.
WARNING:
• The extracted air may not be vented into a flue
which is used for the waste gas from appliances
which are powered by gas or other fuels.
• When venting the extracted air, comply with the
regulations of the relevant local authorities.
The hood has an upper air outlet to vent cooking
odors to the outside.
Recirculation mode
If you do not have a direct extraction vent to the out-
side; the hood can also work in recirculation mode
(i.e. without an extraction vent to the outside; the
filtered air is released back into the room). In this
case, activated carbon filter as described under
.
"Installing the activated carbon filter for recirculation
mode"
, must be used.
Activated carbon filter are not supplied. You can or-
der the carbon filter from your dealer or in our online
accessories shop, www.bomann-germany.de.
Use the reference number found under
Data".
63
The extracted air is normally vented
vertically. The extracted air can be
vented through the wall units and
the loft floor to the roof ridge.
If there is a conduit under the wall
units, the extraction duct can be
routed so that the extracted air can
be vented horizontally through the
wall.
"Technical
