Dremel 3D40 Flexible Build Plate Instrucciones De Funcionamiento Y Seguridad página 5

DM 2610053078 10-18.qxp_3D40 10/25/18 2:48 PM Page 5
REMOVING YOUR OBJECT FROM THE
BUILD PLATE
Dremel 3D40 operation or until it has
cooled down to at least 60°C (140°F).
Contact with the extruder tip during or after
operation before tip has cooled may result in
personal injury.
The use of protective equipment such as
heat resistant gloves and safety glasses will
reduce personal injuries.
pointing towards yourself and others.
Objects flying off the build plate may result in
personal injury.
hand tools to remove objects from the
build plate. Sudden tool slip and improper
body position during object removal from the
build plate may result in personal injury.
removing objects. Scratches in the build
plate will result in improper object creation.
1. Wait for the extruder to cool before
removing your object.
2. With the object still attached, remove
flexible build plate from the build area.
See page 2 for detailed instructions.
3. Flex the build plate with the object pointed
away from yourself and others. Push on
the back of it with your thumbs using your
other fingers to hold onto the handles,
figure 4. The part will release and will
either fall off or be easy to pull off with
your hand.
Removing Your Object
Do not touch the
extruder tip during
Use personal
protective equipment.
Do not flex the build
plate with the object
Be aware of your body
position when using
Avoid scratching the
build plate when
Removal
Tool
4. For thin or small parts, flexing the build
plate may not be enough to release the
part. In these cases, gently use the object
removal tool to remove the object from the
build plate, figure 5. Push removal tool
away from your hand and body.
REMOVING SUPPORTS
(IF REQUIRED)
Use needle nose pliers to remove supports
that are inside your object or hard to reach.
5
FIG. 4
FIG. 5