Initial Setup - Dremel 3D40 Flexible Build Plate Instrucciones De Funcionamiento Y Seguridad

Ocultar thumbs Ver también para 3D40 Flexible Build Plate:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

DM 2610053078 10-18.qxp_3D40 10/25/18 2:48 PM Page 3
PREPARING BUILD PLATE
Dremel 3D40 operation or until it has
cooled down to at least 60°C (140°F).
Contact with the extruder tip during or after
operation before tip has cooled may result in
personal injury.
plate may break and result in personal injury.
from build plate holder. Contacting with
tempered glass plate edge may result in
personal injury.
build plate is covered with Dremel specified
FIG. 1
Handle
B
A

Initial Setup

Do not touch the
extruder tip during
Do not drop the build
plate. Tempered glass
Do
not
remove
tempered glass plate
Before every build make
sure that the flexible
Notch
Flexible Build
Build Plate
Holder
Latches
build tape. Use of improper build tape may
result in equipment damage and poor object
build quality.
1. Wear a protective glove and use your
finger or a brush to apply provided grease
to the entire vertical threaded rod, figure 3
2. Your build plate consists of two parts: the
flexible build plate, and the build plate
holder. The build plate holder has a
magnetic surface to attach the flexible
build plate to, and it has two notches in
the back and movable latches in the front
to hold down the corners of the flexible
build plate.
3. The flexible build plate can be removed
from the build plate holder by rotating the
movable latches towards you (A), lifting
the flexible build plate up by the blue
handles (B), and pulling it out towards you
(C), figure 1.
Plate
3
Notch
Handle
B
A
.
Tabla de contenido
loading

Tabla de contenido