Dremel 3D40 Flexible Build Plate Instrucciones De Funcionamiento Y Seguridad página 4

Ocultar thumbs Ver también para 3D40 Flexible Build Plate:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

DM 2610053078 10-18.qxp_3D40 10/25/18 2:48 PM Page 4
4. The flexible build plate comes with build
tape installed. To remove it, lift it up from
the tab at the front corner and slowly peel
off. To install a new build tape, remove
adhesive liner from build tape and place
build tape over flexible build plate. For
best results, apply build tape at center of
flexible build plate and smooth outward to
remove any air bubbles, figure 2.
5. The flexible build plate can be installed on
top of the build plate holder by sliding it
backwards at an angle so that the corners
of the flexible build plate slide under the
notches at the back of the build plate
holder. Release the flexible build plate so
it sticks on top of the magnet, and close
the latches at the front to hold it in place.
TIP: It is much easier to remove and
install the flexible build plate if the build
plate holder is already installed in the
printer. In general, once the build plate
holder is installed in the printer you do not
need to remove it, you only need to
remove the flexible build plate.
Apply grease here
FIG. 3
Initial Setup
Flexible
Build
Plate
6. The build plate holder can be removed by
pinching the clip located at the front of the
build platform and lifting the build plate
holder off the base, figure 3.
7. Install the build plate holder using the build
platform clips.
Clip
L IF T
Clip
4
FIG. 2
Build
Tape/Sheet
Clip
Tabla de contenido
loading

Tabla de contenido