ENGLISH
results. Always make sure they are completely dry before installing them again;
otherwise, moisture can reach the robot vacuum cleaner's motor and damage it.
Cleaning the fall-detection sensors
Use a clean, dry and soft cloth to wipe off any dust from the fall-detection sensors
located on the robot vacuum cleaner's lower part.
Sensors
- The robot vacuum cleaner has different types of sensors, for example, proximity
sensors that allow the robot to move around while detecting obstacles, or fall-
detection sensors that help the robot detect slopes or possible gaps/unevenness such
as staircases. These sensors are always in contact with dust particles, and therefore
can deteriorate over time, causing possible navigation errors.
- It is recommended to clean all sensors of the robot vacuum cleaner every 35 hours of
use or less, using a soft, dry cloth.
Charging base.
Likewise, the charging base includes charging terminals and the signal transmission
area. Use a clean, dry, soft cloth to wipe dust from these areas.
Charging and replacing the battery
- To extend battery life, leave the robot vacuum cleaner charging on the self-emptying
base whenever not in use.
- Remove the battery and store it in a safe, dry place if the device will not be used for
a long period of time.
- To replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery compartment, remove the battery cover and
the battery. Fig 1.
2. Insert the new battery with the battery label facing up.
3. Put the battery and the battery cover in back in place and properly fix the screws
40
EVVO ROBOT ASPIRADOR R9D LÁSER
