GE Advantium PSA9120 Manual Del Propietário página 35

Ocultar thumbs Ver también para Advantium PSA9120:
Idiomas disponibles

Idiomas disponibles

Care and Cleaning
Advantium
Oven
Replacing
the
surface
light
q.
.
.
.
To replace the surface light, first
disconnect
the power at the main
fuse or circuit breaker panel or
unplug the oven.
Remove the screw from the side of
the light compartment
cover and
lower
the cover until it stops.
Be sure the bulb to be replaced is
cool before removing.
Gently pull
the bulb from the receptacle.
Replace with a 730 volt, 50-watt
halogen bulb.
Order WBOSX7005 7
from your GE supplier.
Raise the light cover and replace
the screw. Connect electrical
power to the oven.
Remove screw
Removing
and cleaning
the filters
q.
.
.
.
The metal filters trap grease
released by foods on the cooktop.
They also prevent flames from
foods on the cooktop from
damaging
the inside of the oven.
For this reason, the filters must
always be in place when the hood
is used. The vent filters should
be cleaned once a month, or as
needed.
To remove, slide them to the rear
using the tabs.
Pull down and out.
To clean the vent filters, soak them
and then swish around in hot water
and detergent.
Don't use ammonia
or ammonia
products
because
they will darken the metal.
Light
brushing can be used to remove
embedded
dirt.
5.
.
Rinse, shake and let dry before
replacing.
To replace, slide the filters into the
frame slots on the back of each
opening.
Press up and to the front
to lock into place.
Replacing
the
oven cavity
lamp
q.
2.
.
.
Disconnect
power at the main fuse
or circuit breaker panel.
Remove the top grill by removing
the two screws that hold it in place.
Remove charcoal filter if present.
Slide the filter toward the left and
pull toward the front to remove.
Note:
Charcoal filter is an optional
kit, you may not have one.
Remove the screw holding the lamp
shield in place.
5.
.
.
Pull the lamp shield out. Pull the
light bulb out and replace with the
120V-130V, 20-watt
halogen bulb.
Order WB2`SX10019 from your GE
supplier.
Return the lamp and lamp shield to
original position and replace screw
and charcoal filter.
Replace the grill and 2 screws.
Reconnect power to the oven
35
loading