Idiomas disponibles
Idiomas disponibles
Mounting Bosch GTS15-10 Table Saw
to GTA50W Stand
(Fig. 11)
All the hardware needed for this procedure is in
Bag E.
1. Align the saw as shown in Fig. 11.
2. Insert one (1) Hex Head Bolt through one (1)
Flat Washer, the mounting hole in the table
saw, and through the Saw Mounting Bar C of
the stand.
3. Place one (1) Flat Washer. Install one (1) Lock
Nut, and use the 5 mm hex key and a 13 mm
wrench to securely tighten the hardware.
4. Repeat the steps above for the three remaining
mounting holes.
Fig. 11
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 9
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 9
Mounting Table Saw to Stand
C
C
-9-
4/26/2023 11:32:14 AM
4/26/2023 11:32:14 AM
