Idiomas disponibles
Idiomas disponibles
Step 3. Attach Linkage Bars to
Support Bars
(Fig. 5)
All the hardware needed for this procedure is in
Bag C.
1. Insert the end of the Left Linkage Bar F into the
Left Support Bar H and align the holes of both
bars.
2. Insert two (2) Hex Head Bolts through the holes
of the Left Linkage Bar F and Left Support Bar
H. Install two (2) M8 Lock Nuts, and use the
5 mm hex wrench and the 13 mm wrench open-
ing on the blade wrench (included on table
saw) to securely tighten the hardware.
3. Repeat the steps above for the Right Linkage
Bar G and the Right Support Bar I.
Fig. 5
H
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 6
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 6
Assembly
I
G
F
Step 4. Attach Lower Cross Bar to
Support Bars
(Fig. 6)
All the hardware needed for this procedure is in
Bag D.
1. Insert the ends of the Support Bars H and I into
the Lower Cross Bar J, and align the holes of
both bars.
2. Place one (1) Flat Washer and one (1) Foot
Pad on one (1) Hex Head Bolt. Insert the Bolt
through the holes in the Left Support Bar H and
the Lower Cross Bar J. Install one (1) M8 Lock
Nut, and use the 5 mm hex key and a 13 mm
wrench to securely tighten the hardware.
3. Repeat the step above for the Right Support
Bar I and the Lower Cross Bar J.
Fig. 6
J
-6-
J
H
H
4/26/2023 11:32:13 AM
4/26/2023 11:32:13 AM
I
