Idiomas disponibles
Idiomas disponibles
Step 1. Attach Wheels
(Fig. 3)
All the hardware needed for this procedure is in
Bag A.
1. Mount one (1) Flat Washer and the Wheel B on
the axle of the Wheel Bar E.
2. Place one (1) Flat Washer on the threaded end
of the wheel axle. Thread the Lock Nut on the
threaded end of the wheel axle by hand.
3. Using the 17 mm opening on the blade wrench
provided with the table saw, tighten the Lock
Nut until the Washer does not move freely. Spin
the Wheel B to check tightness. If the Wheel B
doesn't turn freely, loosen the Nut by 1/8 to 1/4
of a turn.
4. Repeat the same steps with the other Wheel B.
Fig. 3
E
B
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 5
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 5
Assembly
Step 2. Attach Linkage Bars to Wheel
Bar
(Fig. 4)
All the hardware needed for this procedure is in
Bag B.
1. Mount the Left Linkage Bar F on the welded
bushing of the Wheel Bar E.
2. Using the 5 mm hex wrench included on the
table saw, securely tighten the Hex Head Bolt
into the welded bushing.
3. Repeat the steps above for the Right Linkage
Bar G assembly.
Note: The Right Linkage Bar G features a welded
pin while the Left Linkage Bar F does not.
Fig. 4
-5-
G
F
E
4/26/2023 11:32:13 AM
4/26/2023 11:32:13 AM
