Idiomas disponibles
Idiomas disponibles
CO0CTD
(CT
Oooo
or DT OOdD
2
@ STANDBY/ON
TIMER
SETTING THE TIMER
8 Get ready for the source.
In©
timer playback mode
To listen to CDs
Load discs on the disc trays. Play will begin with the disc in the
most recently used disc tray.
To listen to a tape
Insert a tape into the deck. Play will begin with the tape in the
most recently used deck.
To listen to the tuner
Tune in to a station.
To listen to connected sources
Set an extemal timer to turn the connected source on and off.
(See the operating instructions of the connected source.)
In 2 timer recording mode
After the preparation for each source above, set the tape to be
recorded on into deck 2. (See steps 1 to 3 on page 54.)
9 Adjust the volume and tone.
10Press the POWER button to turn the unit off.
Check whether © or 2) is displayed, and the function buttons
turn off. It shows that the unit enters timer standby mode. When
the timer-on time is reached, the unit is turned on and play
begins using the selected source.
Display during timer-on period
When the power is turned on by the timer, SLEEP and 60 are
displayed for 4 seconds.
It shows the period of the time until the
power is off.
To change the timer-on period
in step 7, during the 4 seconds that TIMER is displayed, press the
<4<4 DOWN or & & UP button to specify the timer-on period.
You can select a timer-on period between 10 and 240 minutes in
10-minute steps.
To cancel timer standby mode temporarily
Press the TIMER button so that © or nee goes out in the display.
To restore timer standby mode, press the TIMER button to display
Oor 19) :
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat steps 8 and 9 to select the
correct sources and volume.
To change the specified time and source
Carry out all the steps again.
To check the specified time and source
Press the TIMER button.
The timer-on time and the selected
source name are displayed for 4 seconds..
¢ Timer playback and timer recording will not begin uness the
power is turned off.
* Connected equipment cannot be turned on and off by the built-in
timer of this unit. Use an external timer.
* The timer-on period is not displayed after setting.
