Idiomas disponibles
Idiomas disponibles
Installation instructions
1.2 FACTORY SUPPLIED ACCESSORIES
Description
ATW-RTU-08 (Receiver + Thermostat)
Screw and plug
Installation and operation manual
Product fiche
1.3 INSTALLATION INFORMATION
As these products communicate using RF technology special
care must be taken during installation. The location of the RF
components as well as the building structure may influence
performance of the RF system. To assure system reliability,
please review and apply the information given below.
Within a typical residential building the two products should
communicate reliably within a 30m range.
It is important to take into consideration that walls and ceilings
will reduce the RF signal. The strength of the RF signal
reaching the RF Receiver depends on the number of walls and
ceilings separating it from the Room Thermostat, as well as the
building construction. Walls and ceilings reinforced with steel
or plasterboard walls lined with metal foil reduce the RF signal
significantly more.
1.4 RF RECEIVER INSTALLATION
1 Disconnect the main power from the system.
To ensure your safety, always make sure main power is
switched off before accessing wiring.
2 Remove the cover from the RF receiver.
3 Mount the wiring plate to the wall or wallbox.
?
N O T E
The plugs and mounting screws required are supplied.
4 Connect the RF Receiver wiring.
•
Connect the H-LINK cable.
•
Place the cable through the orifice identified by marker 3.
•
Connect the power cable (L = Live ; N =Neutral) (Tightening
torque 0.50 Nm)
•
Place the power cable in the cable guide identified by
marker 1.
3
PMML0582 rev.1 - 12/2021
5 The cables must be positioned in the box's cable guides in
order to guarantee the pull-off strength.
Quantity
1
4
1
1~ 230V 50Hz
1
L
N
(1) Power cable type cannot be lighter than the specified in 60245 IEC 57.
6 Attach the cover of the RF receiver to the wiring plate.
7 Reconnect the mains power to the system.
1.4.1 Dimensional data
1.4.2 Description of the parts
1.4.3 Technical data
•
Supply voltage: 230V/50Hz (30mA)
•
Wattage: 7W (maximum)
•
Dimensions (mm): 123 x 115 x 37
•
Weight (g): 214g
•
Class 2 reinforced insulation device
•
Overvoltage category: Class 2
•
Pollution category: Class 2
•
Operating Temperature: 0°C to + 60°C
•
Operating Humidity: between 30% and 80%
•
Equipment protection rating: IP21
•
Maximum altitude for use: < 2000m
ATW-RTU-08
H-LINK
L N
YUTAKI
YUTAKI
CB
1 2
Terminal
Terminal
Board
board
H-LINK
98
80,79
Power cord
Not
H-LINK
used
connection cable
Item
Notes
CB
Circuit Breaker 5A
Cable
2 x 0.75
(1)
Bind
button
Operation and
status LED
