Idiomas disponibles
Idiomas disponibles
WARNING:
positioning (Fig. 8c). Do not stand too far
from the machine. Proper reaction and
control may not be achieved in the event
of kickback.
b. Keep the auger bit away from your
body and the auger bit pointing
downward at a 90°angle to the
surface.
c. Set the direction of rotation and
rotation speed.
d. Lift the machine above the surface.
Press and hold the lock-off button
and squeeze the switch trigger.
WARNING:
auger bit when the product is switched
on.
e. Allow the auger to gain full speed.
f. Lower the auger bit into the surface
maintaining the 90°angle (Fig. 8d).
Allow the auger bit to bite into the
material, letting the machine do the work.
g. As the auger bit begins to fill with debris, it is important to constantly clear it to
produce a clean cut and reduce the amount of effort required – while the auger
is operating at full speed, slowly lift it from the hole and allow the debris to clear
from the auger bit.
h. After using this machine, release the trigger switch and allow the auger to come
to a complete stop.
i. When leaving the machine, such as during a break, do not leave the machine
inserted in the soil/ice or lean it against a wall. Install the blade guard onto the ice
auger bit and store the machine in a stable position.
Avoid improper
Do not touch the
EARTH/ICE AUGER — EG0800/EG0800-FC/IG0800/IG0800-FC
8c
8d
90º
27
