Idiomas disponibles
Idiomas disponibles
To Install the Ice Auger Bit
(Fig. 4a & 4b)
Required tool (provided):
Allen key (6 mm)
1. Loosen and remove the locking
screw from the ice auger bit.
2. Mount the upper end of the auger
bit onto the drive shaft of the power
head.
3. Align the connection holes on the
auger bit and drive shaft.
4. Use the locking screw to secure
the auger bit to the drive shaft. Use
the 6 mm Allen key to tighten the
locking screw securely.
NOTICE:
Make sure the locking screw is
inserted in the connection holes from the
flat side of the auger bit hole.
EARTH/ICE AUGER — EG0800/EG0800-FC/IG0800/IG0800-FC
4a
4b
Drive Shaft
Drive Shaft
Ice Auger Bit
Locking Screw
Flat Side
21
