Disposal And Recycling; Ordering Replacement Parts - EINHELL BT-LS 810 DB Manual De Instrucciones

Anleitung_BT_LS_810_DB_SPK7:_
7.3.2 Changing the hydraulic oil (Fig. 32-34)
The hydraulic oil should be changed after every
300 hours of operation.
1. Ensure that the splitter is fully extended.
2. Remove the oil filler screw (Fig. 32).
3. Undo the oil drain screw (Fig. 34) and place a
vessel with a capacity of at least 9 liters under
the oil drain screw.
4. Remove the oil drain screw fully by hand so that
the oil drains into the vessel.
5. When all the oil has drained, clean the oil drain
screw and screw it back into position.
6. Place a funnel in the opening in the oil filler
screw and pour in 4 liters of hydraulic oil.
7. Clean the oil dipstick at the oil filler screw and
check the oil level by inserting the dipstick into
the opening in the oil filler screw. The oil level
must be between the two marks on the oil
dipstick (Fig. 37).
Only steps 2, 6 and 7 are required to fill the wood
splitter for the first time.
Recommended hydraulic oil
We recommend that you use one of the following
makes of hydraulic oil for the hydraulic cylinder:
SHELL TELLUS T22
ARAL VITAM Gf22
SP ENGERGOL HCP22
MOBIL DTE11
or an alternative of the same quality
7.3.3 Cleaning/Replacing the oil filter
Undo the screw connection in the hydraulic line (Fig.
35a/Item A) and the four screws on the sealing plate
(Fig. 35a/Item B). Then carefully pry out the sealing
plate with a screwdriver, taking care not to damage
the sealing plate as you remove it. The oil filter can be
removed with the hydraulic line by turning it (Fig. 36).
Clean the oil filter with a cloth or replace it. Install it in
reverse order.
7.3.4 Pressure control valve (Fig. 38 / Item A)
The pressure control valve was set correctly at the
factory and must never be adjusted.

7.4 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
01.04.2011 8:19 Uhr Seite 23
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
23